![plug in your cm device to get started plug in your cm device to get started](https://sc01.alicdn.com/kf/HTB1MfemaEUIL1JjSZFrq6z3xFXaQ/228240200/HTB1MfemaEUIL1JjSZFrq6z3xFXaQ.jpg)
Then you DO need to download and use the lighting control software utility. The other end of that plugs into a mobo (10-1) pin USB2 header. You use the other cable with THREE holes in one end, and plug it into the OTHER (3-pin) socket on the cooler side. (b) INSTEAD of that, if you choose, or if you have no 4-pin plain RGB mobo header (this appears to be your case, OP) you do not use that cable. If you use this method you do not need the special software for the Wraith Prism. If you have such a header, this way you can synchronize the Prism's display with your other plain RGB lights. (a) connect a cable with FOUR holes into a recessed 4-pin socket on the side of the cooler, and the other end of this goes to a mobo 4-pin (12 VDC) PLAIN RGB header IF you have one. This device and its antenna(s) must not be co-located or operated in conjunction with any other antenna or transmitter.There are two connections to make with the Wraith Prism, and one NOT to make.įirst, its female 4-pin FAN connector must plug into your mobo's CPU_FAN header. To maintain compliance with FCC’s RF exposure guidelines, This equipment should be installed and operated with a minimum distance of 20 cm from the radiator of your body. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This device complies with part 15 of the FCC Rules. –Consult the dealer or an experienced radio/TV technician for help. –Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. –Increase the separation between the equipment and receiver. –Reorient or relocate the receiving antenna. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: However, there is no guarantee that interference will not occur in a particular installation.
![plug in your cm device to get started plug in your cm device to get started](https://www.smartdigital.com.au/wp-content/uploads/RD602-t.jpg)
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. FCC WARNING STATEMENTĬhanges or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Please do not touch it before the power is unplugged and fully cooled.
![plug in your cm device to get started plug in your cm device to get started](https://i.ytimg.com/vi/fc6Sxpd7-2U/maxresdefault.jpg)
![plug in your cm device to get started plug in your cm device to get started](https://digilent.com/reference/_media/reference/pmod/pmodjstk2/pmodjstk2-5.png)
PLUG IN YOUR CM DEVICE TO GET STARTED MANUALS
6.2 Related Manuals / Resources SAFETY INSTRUCTIONS